The Thickness Gauge PenTest can be used everywhere
for simple and quick coating thickness measurement
of all non-magnetic coatings on steel up to a maximum of 700 μm.
Designed as small as a pen, the gauge enables pinpoint measurement
in areas which are difficult to access.
PenTest works on the magnetic attraction principle according to DIN EN ISO 2178.
This principle uses the attractive force of a special permanent magnet
as a measure of the coating thickness.
The gauge is factory pre-set and can be used immediately at any time
without power supply or battery.
Dimensions: ∅ 12 mm x 140 mm
Measuring range: 25 μm ....700 μm
Minimum area for measurement: ∅ 25 mm
Tolerance: ± 10 % of reading*
Ambient temperature: -10 °C up to +80 °C
* when measuring in vertical or horizontal position